DXLink Twisted Pair Input and Output Boards
114
Enova Digital Media Switchers - Hardware Reference Manual
EDID Resolutions Supported through Local DDC
This section covers all of the default EDIDs. In the System Configuration interface, the EDIDs contained in this section's
tables are displayed in a single dropdown menu (General section, Preferred EDID menu) and VICs are differentiated by
the presence of a "p" or "I" in the format.Standard and established timings are given in the tables following along with
detailed timing blocks.
IMPORTANT:
The EDID can be configured to support additional resolutions through the local DDC using the EDID options in
the System Configuration interface (see page 140).
NOTE:
The Consumer Technology Association (CTA) was formerly known as the Consumer Electronics Association (CEA):
the CEA 861 video standard has been renamed to CTA 861.
Standard Timings (Default Shipping EDID)
NOTE:
The default EDID can be overwritten to include a broad range of features, based on installation requirements.
Enova DGX DXLink Twisted Pair Board - Specifications (Cont.)
Audio Sample Rate
32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Local Audio Support
Insertion and/or extraction of 2 CH L-PCM selectable by channel.
EDID Support
• EDID provided by Enova DGX Digital Media Switcher to the digital (HDMI) input on the DXLink Multi-
Format TX
• EDID is user re-programmable
HDCP Support
• Full matrix HDCP support (includes any input to any or all outputs)
• key Management System
• AMX HDCP InstaGate Pro Technology
• key support up to 16 destinations per output, independent of source device
CEC Support
None
ICSP, TCP/IP, USB, IR, and
Control Management
Control Distribution is managed by the Enova DGX Digital Media Switcher on-board NetLinx NX Master
and Ethernet Switch.
USB (HID) Transport
Use the Enova DGX Digital Media Switcher in conjunction with DXLink Transmitters and Receivers
(twisted pair and/or fiber), connect a DXLink Transmitter to a PC and a DXLink Receiver to a keyboard
and mouse, the system then emulates commands from the receiver back to the PC.
Note: A list is available of HID devices which have been tested and found to be working well with the
latest firmware (see "DXLink -HID supported Devices" on the DXLink Receiver’s product page at
www.amx.com).
DXLink Twisted Pair Power
DXLink Twisted Pair Transmitters and Receivers can have power supplied over twisted pair cable when
connected to a DXLink Input or Output Board on the Enova DGX Digital Media Switcher
Input Board Propagation Delay
5
μ
s
Output Board Propagation Delay 5
μ
s
Audio Switching Board Support
Supports break-away audio switching of 2 CH L-PCM for all channels and down-mix Dolby True-HD,
Dolby Digital, DTS-HD or DTS for one input channel.
Connectors
4 RJ-45 ports
Twisted Pair Cable Type
Shielded Cat6, Cat6A, Cat7
Note: For more details and helpful cabling information, reference the white paper titled "Cabling for
Success with DXLink" available at www.amx.com or contact your AMX representative.
Twisted Pair Cable Length
Up to 328 ft. (100 m)
Note: For more details and helpful cabling information, reference the white paper titled "Cabling for
Success with DXLink" available at www.amx.com or contact your AMX representative.
Important Notice
DXLink twisted pair cable runs for DXLink equipment shall only be run within a common building.
Note: A "Common building" is a building in which the walls of the structure(s) are physically connected
and the structure(s) share a single ground reference.
Resolution
Refresh Rate Max
1920x1080
60 Hz
Preferred timing (identified in the EDID)
1920x1200
60 Hz
1680x1050
60 Hz
1600x1200
60 Hz
1600x900
60 Hz
1400x1050
60 Hz
1440x900
60 Hz
1360x765
60 Hz
1280x1024
60 Hz
1280x900
60 Hz
1280x800
60 Hz
1280x720
60 Hz
