Control Panel
77
Enova Digital Media Switchers - Hardware Reference Manual
Software Version
The Software Version Screen provides the following information:
Driver
– Control Panel’s firmware version
Built
– date the Control Panel’s software was built
Host
– software version of the initial operating system (IOS) for the Control Panel
XNet ID
– Control Panel’s XNet device number
FP Link baud 9600
– indicates the Control Panel (FP = Front Panel) and the baud rate
Use the following steps to check the software version information for the Control Panel.
Checking Software Version Information
1.
Press the
Function
key. The Function menu appears.
2.
Locate
Setup Options
by scrolling with the Control Dial.
3.
Press the
Select
key. The Setup Options sub-menu appears. Locate
Software Version
by scrolling with the Control Dial.
4.
Press the
Select
key again to choose
Software Version
. The Software Version Screen appears.
5.
Scroll with the Control Dial to see additional Software Version information.
6.
Press the
Cancel
key to return to the Setup Options sub-menu.
- or -
Press the
Function
key to return to the Function menu.
Master Info
NOTE:
The enclosure must be connected to a network before its IP address will display. Also note that IPv6 addresses are
truncated to fit the 20 character limit on the LCD.
The Master Info Screen provides the following information for the integrated Master:
System Number
– indicates the system number
Serial Number
– indicates the system’s serial number
MAC Address
– indicates the system’s MAC address
IP Address
– indicates the IP address*
IP Device Type
– indicates either DHCP or non-DHCP
Subnet
– indicates the Network setting for the subnet mask*
Gateway
– indicates the Network setting for the gateway
Host Name
– indicates the host name for the system
DNS Address
– indicates the DNS IP address for the system*
Master Version
– indicates the version of the integrated Master
Switcher Version
– indicates the version of the switcher
Controller Version
– indicates the version for the controller
Use the following steps to check information for the integrated Master.
Checking Integrated Master Info
1.
Press the
Function
key. The Function menu appears.
2.
Locate
Setup Options
by scrolling with the Control Dial.
3.
Press the
Select
key. The Setup Options sub-menu appears. Locate
Master Info
by scrolling with the Control Dial.
Version number
