Ammann 5932003, Руководство по эксплуатации

Страница: 65 / 174

61 ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
2.7.2 Drive and reverse drive
Before moving off, check that the articulation joint of the machine is locked.
Before moving off, check that the area in front of and behind the machine is empty and that there are no persons or
obstructions there!
Use the warning horn to signal that the engine is starting and wait long enough so that all persons could leave the area
around the machine or under the machine in time!
The operator must sit on the seat before the machine starts moving! If the operator stands up from the seat while
driving for more than 3 seconds, the machine will stop and the brake will be engaged.
Start the engine
• The engine speed control (18) must be in its lower position.
• Turn off the parking brake switch (17) if the parking brake indicator lamp (29) lights.
Selection of the working engine speed
• The machine is provided with two working speed positions.
• Small working speed: Set the control to the position I (85%).
• Big working speed: Set the control to the position II (100%).
Small working speed:
• 85% travel speed (depending on the transport and working speed change-over switch)
• 85% engine speed
Big working speed:
• 100% travel speed (depending on the transport and working speed change-over switch)
• 100% engine speed
Selection of the travel direction
• Using the travel control (10) select the forward (F) or reverse (R) travel direction from the zero position (0).
When the driver releases the travel control (10), it does not return to the zero position automatically. The travel control remains in the
selected position.
When the driver moves the travel control (10) through the zero position (0) from the selected direction of the machine travel, e.g. due
to a dangerous situation, the machine will stop (panic response).
Travel speed selection
• The travel speed corresponds to the deflection of the travel control (10) from the zero position (0) at the given engine speed (18)
and mode of operation (3) of the machine.
• The travel speed can be changed with the transport and working speed switch (3).
• The travel speed can be changed by selecting the working speed of the engine (18).
Panic response
The immediate stop of the machine using the travel control (10) applies to all of the travel modes of the machine. When the travel
control (10) is changed to the opposite position through (0) within 1 second, the machine will stop – the parking brake will be engaged
and the engine will keep running, i.e. panic response. When the machine vibration is on, the vibration will stop also when the manual
vibration mode is selected. When the machine is equipped with two travel controls, the panic response can be enabled also on the
inactive travel control. The machine can start moving again after the travel control (10) is changed to the neutral position (0) and the
travel direction (F/R) is selected.