Ammann 5932003, Руководство по эксплуатации

Страница: 122 / 174

118 ARX 23-2 T4i, ARX 26-2 T4i
593033
3.6 Lubrication and maintenance operations
3.6.15 Battery inspection
Stop the engine.
Clean the surface of batteries.
Check the condition of the terminals and clamps. Clean the
terminals and clamps. Apply a thin layer of grease on the
terminals.
MAINTENANCE-FREE BATTERY
In case of a maintenance-free battery version (the battery
has no accessible plugs), check only the rest voltage on the
terminals. The batteries cannot be refilled. If the rest voltage is
12.6 V and more, the battery is fully charged. If the rest voltage is
below 12.4 V, the battery should be charged immediately. After
the battery is charged, leave it to stand for 2–3 hours and then
measure the voltage again. The mounting is recommended 24
hours after the charging.
Note
The rest voltage is the voltage measured at the terminals of the
battery, which was at rest for at least 12 hours – it was not either
charged or discharged.
Do not turn the battery upside down; the electrolyte may
pour down from the degassing plugs.
If the electrolyte is spilled, wash the affected area with
water and neutralize with lime.
Hand over the old inoperative battery for disposal.
Keep the battery dry and clean.
Do not disconnect the battery when the engine is
running.
When working with the battery always follow instructions
of the battery manufacturer!
Disconnect the battery for repair or while handling
wires and electrical components in the wiring circuit to
prevent short-circuit.
When disconnecting the battery, first disconnect the
cable of the (–) pole. When connecting the battery, first
connect the (+) pole.
Use rubber gloves and eye protection devices when
handling the battery.
Use suitable clothing to protect your skin against contact
with the electrolyte.
After eye contact with the battery electrolyte,
immediately flush the affected eye thoroughly with
running water for several minutes. Then seek medical
advice.
After ingestion of the electrolyte drink large quantities
of milk, water or suspension of magnesium hydroxide in
water.
In case of skin contact with electrolyte, remove your
clothing and shoes, wash the affected skin immediately
with soap and water or with solution of water and soda.
Then seek medical advice.
Do not eat, drink and smoke while working!
After completing the work, wash your hands and face
thoroughly with water and soap!
Do not check that a wire is live by touching the machine
frame.
Never make direct conductive connection between both
poles of the battery to avoid a short circuit and a risk of
explosion of the battery.