Amada ML-2550A, Руководство по эксплуатации

Страница: 70 / 229

70
ML-2550A/2551A
1. Setting Welding Schedules
SEAM Screen
On the SEAM screen, the fade-in/out function of seam welding is set. The fade-
in/out function means a laser output value adjusting function. This function lowers
and raises the later energy in a gentle slope form to provide a continuous waveform
suitable for seam welding.
How to see the displayed items
: Settable item
Scrolls the POINT display column of POINT 01 to POINT 20 to the right and
left. When a POINT is not displayed, press this button to display it.
SHOT [COUNT]
Sets the laser light output count of POINT 01 to POINT 20 in the range of 0000
to 9999.
POWER [%] Sets the laser output value of each "SHOT" of POINT 01 to POINT 20 in
the range of 0 to 150.0% being the ratio to "PEAK POWER" set on the
SCHEDULE screen.
The laser output value is shifted to the output value set for the next POINT in
a gentle slope waveform by the fade-in/out function to adjust the laser output
value.
RESET
Clears all the set values of POINT 01 to POINT 20.
REPEAT
Sets the number of laser light outputs per second in the range of 000 to 500
pps (pulse per second). When 0 is set, the single output is set.
Common to "REPEAT" on the SCHEDULE screen.
SHOT Sets the number of laser outputs in the range of 0000 to 9999.
When the laser output count reaches the set value, the laser output is stopped.
When 1 is set, a single-shot output is performed.
When "REPEAT" is set to a value other than 0 and "SHOT" is set to 0, laser
light is continuously output until a laser stop signal is input.
Common to "SHOT" on the SCHEDULE screen.
⇒ For the common items in the upper/lower part of the screen, refer to page 63.