Amada ML-2550A, Руководство по эксплуатации

Страница: 147 / 229

3. Initial Settings
147
ML-2550A/2551A
Chapter 5 Laser W
elding by External Communication Control (RS-485 CONTROL)
Introduction Part
Operating Part
Maintenance Part
Appendixes
Installation
and
Preparation
Part
3. Initial Settings
Perform initial settings to control laser welding by external communication (RS-
485 CONTROL). Set communication schedules and equipment No. on the laser
controller of the laser.
The communication schedules for data transfer are as follows.
Data transfer system Conforming to RS-485, asynchronous, full duplex
Transfer rate 9600, 19200, 38400bps
Data type Start bit 1
Data bit 8 or 7
Stop bit 2 or 1
Parity bit Even/odd/none
Character code ASCII
⇒
Set the transfer rate, data type, and equipment No. by displaying the MEMORY
SWITCH screen from the INITIALIZE screen by the laser controller of each
equipment that is connected to the personal computer, etc.
Setting Communication Schedules
Set the communication conditions by displaying the MEMORY SWITCH screen
from the INITIALIZE screen by the laser controller of the equipment.
1
Displaying the MEMORY SWITCH Screen
(1) Turn OFF the CONTROL keyswitch and turn ON the MAIN SWITCH switch.
Power is supplied and the POWER lamp comes on. The screen of model name
appears.
① ③
④ ②