Amada ML-2550A, Руководство по эксплуатации

Страница: 51 / 229

4. Connecting the Optical Fiber
51
ML-2550A/2551A
Chapter 2 Connections and Preparations of Each Section
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Standard Values of Maximum Incident Laser Energy and Power of the
Optical Fiber
The following table shows the standard values of maximum laser energy and power
that can be input into the optical fiber. Take care not to exceed these values when
using the optical fiber.
For single-delivery or timesharing
The value becomes 1/2 at 2-powersharing, 1/3 at 3-powersharing, and 1/4 at 4-powersharing.
Core dia. Model
ML-2550A ML-2551A
SI φ 0.3mm - 50J, 200W
SI φ 0.4mm 80J, 200W
50J, 300W SI φ 0.6mm
80J, 400W
SI φ 0.8, 1.0mm
⇒
Use the SI optical fiber. The GI optical fiber cannot be used.
Item required
Phillips screwdriver and air blow
1
Connecting to Laser Beam Input Unit
(1) Remove the fixing screws at the upper front of both sides, and turn the operation
panel toward you.
(2) Remove the fixing screws of both sides.
Remove the top cover set screws provided on both sides and pull the top covers
A and B in this order straight upward to remove them.
(3) Remove the branch unit cover.
Top cover A
Top cover B fixing screws
(4 screws in total on both sides)
Control panel
Top cover B
Top cover A fixing screws
(4 screws in total on both sides)
Set screw
for panel