Alvarion 43222600, Системное руководство

Страница: 21 / 129

WBSn-2400 and WBSn-2450 System Manual
Chapter 2 - Base Station InstallationThe Installation Process
Chapter 2 - Base Station Installation The Installation Process
11
The typical installation process comprises the following steps:
1
Choose the locations for the outdoor and indoor equipment (refer to “Location Selection Guidelines”
on page 9 ).
2
Verify the existence of a good protective grounding (earth) connection near the location intended for
the base station.
3
Prepare the outdoor Ethernet cable and connect it to the base station (refer to “Preparing and
Connecting the Outdoors Ethernet Cable” on page 12 ).
4
Prepare the grounding cable and connect it to the base station (refer to “Preparing and Connecting
the Grounding Cable” on page 13 ).
5
If an extender is required, attach it to the post clamp (refer to “Attaching an Extender to the Post
Clamp (optional)” on page 13 ).
6
Attach the post clamp (with the extender if applicable) to the pole/wall and attach to it the base
station. Verify that it is properly directed towards the required coverage area (refer to “Mounting the
Base Station” on page 15 ).
7
For units with Omni antennas: Connect and seal the three antennas (refer to “Connecting and
Sealing Omni Antennas (if applicable)” on page 17 ).
8
Complete the outdoor installation (refer to “Completing the Outdoor Installation” on page 17 ).
9
Install and connect the indoor equipment (refer to “Connecting the Indoor Equipment” on page 18 ).
10
Verify that the unit can be remotely managed (refer to “Verification” on page 19 ).