Alvarion 43222600, Системное руководство

Страница: 25 / 129

WBSn-2400 and WBSn-2450 System Manual
Chapter 2 - Base Station InstallationMounting the Base Station
Chapter 2 - Base Station Installation Mounting the Base Station
15
2.9 Mounting the Base Station
2.9.1 Using the Post-Clamp
The base station should always be installed vertically, with the bottom side (with connectors and LEDs)
pointing downward. To support this requirement, in regular installations (without an extender), the post
clamp should be installed vertically (with the two protrusions pointing up and down). In installations
with an extender, the post clamp should be installed horizontally ((with the two protrusions pointing
sideways).
The slots support installation on poles with different diameters (1”-6”) on either vertical or horizontal
poles. The holes enable wall mount installation.
2.9.2 Wall Mount Installation
1
Place the post clamp on the wall and mark the exact location of the holes to drill. The location of the
screws should be planned with maximum precision.
2
Drill the holes and use four suitable metal anchors and screws to secure the post clamp (with an
extender if applicable) to the wall.
NOTE!
For specific information about mounting the WBSn-2450-SHD in high density environments refer to the
High Density Wi-Fi Solution Guidelines document.
Figure 2-4: Post-Clamp
To mount the unit on a wall: