Altigen AltiWare OE/ACC Version 5.0, Руководство администратора

Страница: 194 / 470

Configuring the Triton VoIP Board
6-10 AltiWare OE System Installation & Administration Manual
Firewall Configuration
Please note the following very important guidelines when working with a
firewall on your network:
• If a firewall is used to protect your network access security,
reconfigure the firewall (as described in “Firewall Considerations” on
page 6-27) to open up TCP and UDP ports to the IP system’s IP
address. This allows IP’s voice and H.323 packets to pass through the
firewall freely. If the firewall supports H.323 protocol, configure the
firewall using H.323 instead of opening up the specific ports.
• Ensure that the rules to permit IP’s H.323 traffic are at the beginning
of your access filter list. This will minimize the delay of latency-
sensitive voice packets. This is ESPECIALLY important with long
access lists and/or slow routers.
Network Using NAT
If you plan to connect to your AltiServ system via the Internet and your
router or Internet access provider is using Network Address
Translation (NAT), please note that most NAT implementations DO
NOT support H.323.
• You are probably using NAT if both of the following conditions
apply:
— Your AltiServ server's IP address matches any of the following
numbers (where x is any number from 0-255):
• 10.x.x.x
• 172.16.x.x to 172.32.x.x
• 192.168.x.x
— You are able to connect to the Internet directly WITHOUT
using a proxy server.
• Contact your router/firewall vendor to obtain a software update for
your networking equipment, or obtain routable address space from
your Internet provider. If you are unsure whether or not you are
using NAT, contact your router/firewall vendor or Internet
provider.