Altigen AltiWare OE/ACC Version 5.0, Руководство администратора

Страница: 61 / 470

Overview
AltiWare OE System Installation & Administration Manual 1-27
1.
O
v
erv
iew
• IP Port Support - AltiWare IP port density is increased to 120 ports.
The system supports up to ten (10) Triton IP boards (120 ports) or, two
(2) G.723 and two (2) G.711 (84 ports).
• Integrated Administration - calls through both PSTN and IP
networks can be managed using a single point of administration.
• Integrated VoIP Gateway - because the VoIP gateway is built-in to
the system, translation of PSTN calls to IP calls and IP to PSTN calls
are smoother and more successful. Also, the Overlap dialing is enabled
and the dialing sequence is smoother for end users. Without the need
for cable configuration and the purchase of additional analog ports,
there can be significant time and cost savings.
IP Group Paging - allows the use of group voice paging to
Alti-IP 600 phone users in a group.
• Jitter Removals - due to various delays in the IP network, audio
packet streams may be delivered late or out of order. AltiWare is able
to buffer incoming packets and re-sequence them by maintaining a
queue. This queue is adjustable to accommodate different network
environment characteristics.
PCM-based Music File - A pre-recorded music on hold file
(AltiGen PCM format) for IP ports can be played.
• Release Link Tie - when transferring between two systems through IP
tie trunks, the trunks can be released by pressing FLASH *.
• Ring-Back Tone Generation - ring back tones can be generated to
other analog trunk or extension lines on behalf of the IP trunk.
• Silence Detection and Suppression - A silence detection feature
enables the following:
— Silence Suppression - when silence suppression is enabled and
silence is detected, AltiWare stops sending packets to the other side.
The other side does not receive any packets and plays silence.
— AltiWare disconnects the voice mail session when a silence period
exceeds 7 seconds during voice mail recording over VoIP.
• VoIP Hop Off Call Support - allows an extension to access a T1 or
CO trunk on the remote system and “hop off’ to dial an outside
telephone number. This “hop off’ feature can be enabled or disabled
on the remote system. Outcall restrictions for hop off calls are
configurable.
NEW
NEW