Allied Telesis AT-x950-28XSQ, Руководство по установке

Страница: 131 / 190

AT-x950-28XSQ Switch and VCStack Installation Guide
131
5 Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
6 Activate VCStack on the switch with the STACK ENABLE command.
awplus(config)# stack enable
% Automatically enabling ‘stack virtual-mac’ to minimize disruption
form failovers.
% Please check that the new MAC 0000.cd37.0431 is unique within the
network.
% Save the config and restart the system for this change to take
effect.
7
Assign priority 1 to the switch with the STACK PRIORITY to ensure that this switch is
selected as the master switch during the first power-on of the stack.
awplus(config)# stack 1 priority 1
% Warning: Stacking is currently disabled.
8
Add the member switch as a provisioned switch, with the ID 2, to the master switch
with the SWITCH PROVISION command. This is so that the master switch already
knows about the member switch during the first power-on of the stack.
awplus(config)# switch 2 provision x950-28
9 Configure ports 25, 29, 33, and 37 on both the master switch (port1) and the
provisioned member switch (port2) for the appropriate transceivers, with the
PLATFORM PORTMODE INTERFACE command. This step is particularly important
if you will be using 100Gbps transceivers for the stack trunk. You can skip this step
and configure the ports after building the stack if you are not using 100Gbps
transceivers for the stack trunk. For more information, refer to “Ports 25 to 37 for
40Gbps QSFP+ or 100Gbps QSFP28 Transceivers, or Breakout Cables” on page 23
and “PLATFORM PORTMODE INTERFACE” on page 121.
The example here configures ports 33 and 37 for 100Gbps transceivers on the master
switch and the provisioned member switch.
awplus(config)# platform portmode interface port1.0.33-1.0.37 100g
awplus(config)# platform portmode interface port2.0.33-2.0.37 100g
10
Enter the port Interface modes of the ports that will be the stack trunk, for both the
master switch and the provisioned member switch. The example command here
assumes that both switches will be using ports 33 and 37 as the stack trunk. Be sure
to modify the command to specify the ports of your stack trunk.
awplus(config)# interface port1.0.33-1.0.37,port2.0.33-2.0.37
Table 16. Configuring the Master Switch (Continued)
Step Description and Command