46
47
5.2. WARNINGS
The appliance has a built-in safety lock. If the lid is not properly placed on the jug or the jug
is not properly placed on the base during use, the warning message "E1" will appear on the
control panel.
The steam and blender function cannot be activated in such a case.
Jug is not properly attached
Jug is properly attached
If the water in the water tank is used up during steaming,
the warning message "E2" will appear on the control panel.
The thermostat will switch off followed by 3 beep tones. If the
water is replenished within 2 minutes, the steam function will
automatically resume where it left off within a few seconds. If no
water is added, the BFP-66 appliance will automatically return to
standby mode.
6. CLEANING AND MAINTENANCE
• Clean the appliance immediately after each use.
• ALWAYS remove the plug from the socket during cleaning and allow the appliance to cool down.
• Carefully unscrew the blade unit from the jug (see chapter 5.1. ASSEMBLY AND DISASSEMBLY) in order to
clean the loose parts thoroughly.
Caution!
The blade unit is sharp. Pay special attention when assembling, disassembling and cleaning it.
• The base can be wiped with a damp cloth.
• NEVER immerse the base in water and do NOT rinse under the tap!
• NEVER place the base on a wet surface.
• NEVER use scouring pads, abrasive cleaners, bleach or aggressive liquids such as gasoline, acetone or
alcohol to clean the device or accessories.
• Hard water causes deposits in the water tank. We recommend removing this limescale every 2-4 weeks.
Descaling should ONLY be done with white vinegar.
Caution!
Make sure the appliance is completely turned off and no longer hot.
Follow the instructions below:
1. Pour the white vinegar solution (60 ml white vinegar and
60 ml water) into the water tank until it is half full and screw
the lid onto the water tank.
2. Allow the solution to stand for approximately 6 to 12 hours
until the limescale has completely disappeared. If the
limescale is not completely dissolved, repeat the previous
steps until the water reservoir is completely clean.
3. Pour the solution out of the water tank and rinse well with
water. Rinse the lid well under the tap.
4. Fill the water tank with 250 ml of water (up to the
MAX indication) and go through 1 steam cycle without
ingredients, before you resume preparing food.
5. Finally, dry the water tank with a soft cloth.
5.3. STAND-BY MODE
In standby mode, the horizontal stripes flash and no function is activated.
To completely turn off the control panel, unplug the power cord or press the power/pause button
for approximately 3 seconds.
• Rinse the dishwasher safe parts (see drawing below) off under the
tap before placing them in the dishwasher.
• Dry all parts before replacing and storing them.
• All parts that come into contact with food, such as the steam basket,
the spatula and the jug may discolour. This is normal and not
harmful to the preparation of the food.
• The BFP-66 requires no maintenance other than cleaning and
descaling.
NOT
DISHWASHER PROOF:
IS
DISHWASHER PROOF:
1
60
2
120
4
3
5
6
Lid is not properly attached
Lid is properly attached
