Airwell EFL 100-3R410, Техническое руководство, Страница: 94 / 328

3
3 - 57
Control of 3-WAY FLOW LOGIC
4. System Controller / NRSC-FL
(b) Zone regi s tration u s ing the s y s tem controller (NR S C-FL)
✟
In this case, yo u set all Central addresses by system
controller at once man u ally.
(1) Press the and b u ttons at the same time
for more than 4 seconds.
and CODE No. C1 will flash.
(2) After confirming that CODE No. C1 is displayed,
press the b u tton. Once in this mode, a change
takes place as Fig. 3 - 3 8.
( 3 ) Select the zone and gro u p No. which yo u want to set
with and (GROUP) b u ttons.
If already set, press the b u tton.
(4) Set the u nit No. (Indoor u nit address) with and
b u ttons, according to the zone registration table.
R.C. No. .......................... b u tton
Indoor u nit No.................. b u tton
(5) Press the b u tton.
GROUP No. t u rns ON and UNIT No. (Indoor u nit
address) changes from flashing to ON state. UNIT
No. is registered to selected ZONE No. and GROUP
No.
If yo
u make a mistake, then press the b u tton and
reselect the ZONE, GROUP and UNIT No.
(6) Register the other UNIT Nos. in the same way by
following the steps ( 3 ) to (5).
(7) Finally, complete the registration by pressing the
b u tton.
flashes for a few min u tes, then goes OFF.
Selected
gro
u p No. if
no data is
registered.
If no data is
registered
no n
u mber
is displayed.
If data is
registered
the
u nit No.
is displayed.
Fig. 3 - 3 8
Fig. 3 - 3 9
For example, in the case at left
Zone 3 , gro u p No. 7
Unit No. (indoor u nit address) 2-8
Unit No. 2-8 is registered to zone 3 -gro u p 7.
(c) Automatic zone regi s tration u s ing the s y s tem controller
(NR S C-FL)
(1) Press the and b u ttons at the same time for more than 4
seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C2 by pressing and ( ) b u tton
and press the b u tton.
C2 changes from flashing to ON state and a u tomatic zone
registration will start.
( 3 ) All registerd GROUP Nos. will disappear.
(4) Central addresses will be assigned from small indoor u nit addresses
to large addresses in n u merical order a u tomatically.
After a u tomatic zone registration is completed, changes
(5)
registration finishes at this time. Press the b u tton.
(6) Finally, complete a u tomatic zone registration mode by pressing the
b u tton.
flashes for a few min u tes, then goes OFF.
Fig. 3 -40
If an error occ u rs “CHECK” starts flashing and zone
from flashing to OFF.
04-218 Airwell-3_p39-60.qxp 01/06/2007 13:13 Page 57