Airwell EFL 100-3R410, Техническое руководство, Страница: 93 / 328

3
3 - 56
Control of 3-WAY FLOW LOGIC
4. System Controller / NRSC-FL
(a) Zone regi s tration u s ing the remote controller (NRCG-FL)
(Determination of central address)
In this case, after confirming which indoor u nit is connected to the
remote controller and that the air conditioner in the OFF state, yo u
set the central addresses one at a time.
If the system has no remote controller, connect a remote controller
to the system temporarily. Th en follow this proced
u re.
The indoor u nit address m u st already have been set before performing
zone registration. If necessary, refer to the Installation Man u al s u pplied
with the o u tdoor u nit.
(1) Press the and b u ttons at the same time of the remote
controller for more than 4 seconds.
(2) Do not press b u tton.
( 3 ) Once in this mode, the UNIT No., CODE No., No. of SET DATA and
indications will flash on the display as shown Fig. 3 - 3 6.
In case of gro u p control “ALL” instead of “UNIT No.” will flash on the
display. Select the main indoor u nit address by pressing the
b u tton once.
(4) Set CODE No. to 0 3 u sing the and ( ) b u ttons.
The CODE No. 0 3 m u st be selected to perform zone registration u sing
the remote controller.
(5) Set the Central address which yo u want to assign to the indoor u nit
address u sing the and ( ) b u ttons according to the
zone registration table.
(6) Press the b u tton. The CODE No. and Central address changes
from flashing to ON state. If yo u make mistake, then press the
b u tton and reset the central address.
(7) Press the b u tton to finish zone registration.
NOTE
Fig. 3 - 3 6
NOTE
NOTE
Fig. 3 - 3 7
For example, in this case
Indoor u nit address:1-8
Central address : 17 (ZONE 2, GROUP 1)
04-218 Airwell-3_p39-60.qxp 01/06/2007 13:13 Page 56