Airwell EFL 100-3R410, Техническое руководство, Страница: 51 / 328

3
3 - 14
Control of 3-WAY FLOW LOGIC
2. Wireless Remote Controller
■ ■
RCIRKS-FL for 2-Way and High Ceiling
1-Way Type (NK2FL, NKSL Type)
For 2-way Cassette Type (NK2FL Type)
2-11. Installing the Display
●
Remove panel cover A and install the display.
(1) Remove cover A from the rear side of the panel.
(2) Cover B is fit inside cover A. Therefore, spread
cover A and remove cover B, as shown in Fig. 3-
13.
Remove the tape that holds cover B in place. It
was used for protection during shipping.
(3) Fit the display into the panel.
(4) Pass the display lead wire through the notch in the
panel. Use the hole in the plate and a clamp to
fasten the wire in place.
(5) Reattach cover A.
2-12. Installing the Control Unit
● Do not twist the control wiring with the power wiring
because this may cause malfunction.
● Install a noise filter or take other appropriate action
if electrical noise affects the power supply circuit of
the unit.
(1) Use the 2 supplied screws (4 x 10) to attach the
control unit at the location shown in the diagram
below.
(2) Connect the display and control unit 6P connec-
tors.
(3) Connect the control unit lead wire to the indoor
unit remote controller wiring terminal.
(4) Bend the lead wire into the correct shape, and use
a figure 8 clamp to fasten it in place.
(5) Attach the ceiling panel.
* For the wiring and test run procedures, refer to
“Wiring the Receiver Unit” and “Test Run.”
NOTE
Spread
Cover B
Display
Cover A
Fig. 3-13
Fasten the wire in the hole of the plate.
Pass the display lead
wire through the
notch in the panel.
Fig. 3-14
Bend the excess lead wire,
then use the figure 8 clamp to fasten it in place.
Control unit
Fig. 3-15
04-218 Airwell-3_1-38.qxp 01/06/2007 13:14 Page 14