Air Liquide M 132, Руководство пользователя

Страница: 10 / 52

10
3.5 INSTALLING WIRE SPOOL AND
ADJUSTING HUB TENSION
1 . Install the wire spool (See figure 2)
2 . To increase tension, adjust the 11/16” nut in a
clockwise direction.
3 . To decrease tension, adjust the 11/16” nut in a
counter clockwise direction.
3.6 INSTALLING THE WIRE INTO THE
WELDING GUN
1 . Open the pressure assembly on the wire feeder.
2 . Push wire through guide into gun.
3 . Close and tighten pressure assembly.
4. Remove gun nozzle and contact tip.
5 . Press the gun trigger until wire comes out of
the welding gun.
Typical Weld Parameter Settings: M 132
Fig. 2
Typical Weld Parameter Settings: M 172
6 . Reinstall contact tip and nozzle.
7 . Feed wire by pressing the gun trigger to check
drive roll pressure.
8 . Tighten pressure assembly knob enough to pre-
vent slippage.
9 . Cut off wire and begin welding.