INSTRUCTIONS FOR USE
AGS 1800 - 2000 EN-HV (HVB)
Rev.9/2018
111
16.4
SIGNAL LIGHTS
The signal lights consist of:
•
Red and white reflective signs at the front and the rear
•
Rear lights with a reflective warning triangle
•
Lateral reflectors
•
Front position lamps
16.5
CLEANING THE SPRAYING DEVICE
After every single use of the sprayer, the appliance must be thoroughly cleaned. The best way to use
any excess insecticide is to dilute it with water and spray it on the same surface again. The
concentration should be at least 10% (10 units of water per one unit of insecticide), the spraying speed
slightly faster and the spraying pressure slightly lower (1.5 bar, depending on the nozzle). While doing
this, use the additional reservoir for washing. The procedure is described in the chapter “COMPLETE
CLEANING OF THE SPRAYER”. After that, thoroughly clean the sprayer on the inside and the
outside and also clean all tolls which you have used for spraying (including the tractor). Use only
detergents that are recommended by the manufacturer of protection agents! If there are instructions for
cleaning of the appliance after using it attached to the instructions for using the insecticide, follow
them.
In accordance with the local legislation on washing of the pesticides into the earth, agree on cleaning
of your sprayer with your advisory service.
The ablution of pesticides (cleaning of the sprayer) must not be performed on swampy ground or in the
near of streams, water dams, dykes or water fountains, etc.
If there is still some insecticide inside the sprayer and if you had to stop working unexpectedly for
some time it is recommended to clean the pump, the regulator and the spraying lining with clean water
(see chapter PARTIAL CLEANING OF THE SPRAYER).
In the case you had to stop working unexpectedly but did not clean the sprayer yet, you have to
assure that other people or animals cannot reach the sprayer.
When cleaning the sprayer use appropriate protection clothes. Choose appropriate detergents for
cleaning and, if necessary, appropriate insecticide neutralising agents (see recommendations of the
insecticide manufacturer).
In the case you are using a mixture of detergent and water for cleaning, pour it into the main reservoir,
close the main valve on the pressure regulator, turn on the pump, open the direction control valve for
mixing, open the self-cleaning filter valve and only after few minutes open the direction control valves
of the nozzles. Be careful when choosing the place for releasing of the cleaning agent. Some detergents
become active only after few minutes, so the cleaning process can be slightly longer (see instructions
of the manufacturer).
WARNING:
•
Only a clean sprayer appliance is a safe appliance.
•
A clean sprayer appliance is ready to be used.
•
A clean sprayer appliance cannot get damaged by chemical agents or
chemical solvents.
Содержание 12 HLX
Страница 2: ...INSTRUCTIONS FOR USE AGS 1800 2000 EN HV HVB Rev 9 2018 1...
Страница 24: ...INSTRUCTIONS FOR USE AGS 1800 2000 EN HV HVB Rev 9 2018 23 4 2 SPRAYER COMPONENT PARTS Figure 4 4...
Страница 28: ...INSTRUCTIONS FOR USE AGS 1800 2000 EN HV HVB Rev 9 2018 27 4 4 FUNCTION SCHEME Figure 4 5...
