Advantech EKI-9512-C0IDW10E, Руководство пользователя

Страница: 123 / 326

EKI-9500 Series User Manual 104
4.3.7.6 Source Interface Configuration
Use the Syslog Source Interface Configuration page to specify the physical or logical
interface to use as the logging (Syslog) client source interface. When an IP address
is configured on the source interface, this address is used for all Syslog communica-
tions between the local logging client and the remote Syslog server. The IP address
of the designated source interface is used in the IP header of Syslog management
protocol packets. This allows security devices, such as firewalls, to identify all source
packets coming from a specific device.
To access this page, click System > Logs > Source Interface Configuration .
Figure 4.104 System > Logs > Source Interface Configuration
Console Log Configuration
Admin Mode Enable or disable logging to any serial device attached to the host.
Severity Filter Select the severity of the messages to be logged. All messages at and
above the selected threshold are logged to the console. The severity
can be one of the following:

Emergency (0): The device is unusable.

Alert (1): Action must be taken immediately.

Critical (2): The device is experiencing primary system failures.

Error (3): The device is experiencing non-urgent failures.

Warning (4): The device is experiencing conditions that could
lead to system errors if no action is taken.

Notice (5): The device is experiencing normal but significant
conditions.

Info (6): The device is providing non-critical information.

Debug (7): The device is providing debug-level information.
Persistent Log Configuration
Admin Mode Enable or disable logging to the persistent log. These messages are
not deleted when the device reboots.
Severity Filter Select the severity of the messages to be logged. All messages at and
above the selected threshold are logged to the console. See the previ-
ous severity filter description for more information about each severity
level.
Syslog Configuration
Admin Mode Enable or disable logging to configured syslog hosts. When the syslog
admin mode is disabled the device does not relay logs to syslog
hosts, and no messages will be sent to any collector/relay. When the
syslog admin mode is enabled, messages will be sent to configured
collectors/relays using the values configured for each collector/relay.
Local UDP Port The UDP port on the local host from which syslog messages are sent.
Submit Click Submit to save the values and update the screen.
Refresh Click Refresh to update the screen.
Cancel Click Cancel to restore default value.
Item Description