ADTRAN 606, Системное руководство

Страница: 221 / 264

Total Access 600 Series System Manual Section 5 DLP-13
61200624L1-1B © 2004 ADTRAN, Inc. 219
5. Enable "capture" or "logging" in the terminal software, saving it to a file on your computer.
6. Press the SPACE BAR to continue. The unit prints its configuration to the terminal screen. (With
capture enabled, the terminal software will capture the configuration and write it to the designated file.)
7. When the configuration stops printing, end the capture. The unit configuration is now saved to the
designated file.
8. At the terminal prompt, type EXIT to enter the unit configuration menu.
Loading a configuration into the Total Access 6XX
The following steps explains the process for uploading the text file back into the Total Access 6XX. These
text files can be the entire configuration, or just partial commands that affect specific configuration
changes. The uploading steps are the same, regardless of the size of the file.
1. Establish a connection to the Total Access 6XX with the VT100 terminal software using the CRAFT
port or Telnet via the 10/100BASET Ethernet interface.
2. From the main menu, select S
YSTEM
U
TILITY
, then T
ERMINAL
M
ODE
; press <Enter> .
3. In the terminal software, initiate a SEND TEXT FILE or SEND CFG FILE using the saved configuration
file.
4. Once the file transfer is complete, type SAVE to save the configuration in the unit. Type EXIT to enter
the unit configuration menu.
Entering commands at the command prompt
Precede each instruction with a ">" when manually entering commands at the command prompt. After
entering commands, type
SAVE
at the command prompt. (This applies ALL commands to current
operation and saves all changes.) To save the changes to flash only (without affecting current operation),
return to the menu system and press <
CTRL+W
>.
The commands are based on string comparisons with the menu system (with spaces replaced with
underscores). For example, the config command appears at the command prompt exactly as it appears in
the Total Access 6XX terminal menus. To change a configuration, type in the desired option exactly as it
appears on the menu. For example, to change the T1 timing mode, the command line should read
>interfaces t1 config timing_mode network (sets timing to recover from the network) or
>interfaces t1 config timing_mode internal (sets timing to internal Total Access 6XX oscillator) or
>interfaces t1 config timing_mode dsx-1 (sets timing to recover from the DSX-1 interface).
Always use <
CTRL
+
L
> to exit the configuration menu before closing the Telnet or
terminal software.
Always use <
CTRL
+
L
> to exit the configuration menu before closing the Telnet or
terminal software.