ADS ECHO 9000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 64 / 105

Configuration and Activation 4-3
Reactivating the Monitor
When the final configuration settings are complete, the user will need to reactivate the monitor. The
process will be the same as the
Activating the Monitor section in Chapter 2 , with the addition of setting the
Accelerometer and performing a test of the LRD sensor.
1. Select the monitor that will be activated from the Location Name drop-down list in the Monitor
section on the QstartXML main screen.
2. Verify the configuration parameters and communication method (i.e. designated for Connect ) for the
monitor and modify the parameters as necessary. If the ECHO modem is on ( COMMS light is a slow
flashing green), the activation can be done wirelessly. If not, activate the ECHO using the Bluetooth
dongle as instructed in Chapter 2 .
3. Click on the Activate button in the Functions section. QstartXML initiates and establishes
communication with the monitor and then downloads the appropriate information and files. Once the
activation is complete, the status bar displays an
Activate Successful message. QstartXML generates
an Activation log that is available for viewing through the log viewer within QstartXML .
4. While still online with the ECHO , select the Advanced device. Under the Diagnostics tab, the
Accelerometer must be set to establish a baseline against which it will compare later readings to check
for a Tilt alarm. Click the Set button to set the initial values. This will display reference values for the
X, Y, and Z. The Read button will display a comparison between current values and the initial base
values.
Setting the Accelerometer
5. Continue other activities that require communication with the monitor or disconnect the monitor by
clicking on the
Hangup button in the Functions section. This will cause the local computer to
disconnect from the monitor.
6. To ensure all settings have been configured properly, perform a test fire of the Long Range Depth
sensor. If still online with the ECHO , open the Long Range Depth device dialog. Otherwise,
reconnect with the ECHO by selecting Connect , then open the Long Range Depth device dialog.
When online with the monitor, the dialog will change to allow the user to take readings. Click on the
Read button to initiate the test. Observe the results to confirm proper sensor performance. The sensor
may need to be read several times for the readings to settle in after initial installation. If it appears that
the readings are too high and may be measuring the depth of the manhole bench rather than the depth
of flow in the invert, consider rotating the
Mounting Bar slightly to provide the ECHO a more direct
line of sight to the invert. Get back online and repeat the Long Range Depth firing to verify that the
ECHO is now reading correctly.