Initial Configuration and Activation
2-3
4.
Hold the Blue ADS magnet (ADS p/n 8000-0460) on the
WAKE
activation point for 25 to 30 seconds
until the
SENSE
LED illumines magenta. Hold the magnet for an additional 1 to 2 seconds, then
quickly remove the magnet. The
SENSE
light will begin to rapidly flash a green light and the
COMMS
LED will be a solid green until connected to the network. Once the green light is flashing,
wireless communications will be enabled.
Note: The SIM card should not be activated more than 48 hours before the modem
is initialized.
Downloading the QstartXML Software and Bluetooth®
Driver
The
ECHO
monitor requires the use of a Bluetooth dongle with driver and ADS
QstartXML
software.
The Bluetooth driver and
QstartXML
software can be downloaded from the ADS website at
. Also download the
QstartXML Installation Guide
while on the
software downloads page.
Note:
Download the zipped folder, “
CDM21228_Setup.zip
” from the ADS website (
) onto the computer which will be used for the
ECHO
communication.
Installing the Bluetooth Driver
Bluetooth activation is the recommended method of establishing initial communication with the monitor.
Bluetooth requires near proximity (roughly 8 feet or 2.5 m) to the monitor.
1.
Extract the files to a folder on the desktop. Run the
“CDM21228_Setup.exe”
installer application,
making sure to use the appropriate version for 64-bit systems versus 32-bit systems. To determine if
the system is a 64-bit or 32-bit, open Windows Explorer. Right click the Computer icon and select
properties to view the system type.
2.
Insert the ADS-supplied Bluetooth dongle (P/N ADS 9000-0061) into a USB port. The first time the
Bluetooth dongle is inserted, it may take several minutes for Windows to complete the driver update.
Installing the QstartXML Software
Follow the instructions in the
QstartXML Installation Guide
downloaded from the ADS website
QstartXML-Installation-Guide.pdf (adsenv.com)
) to install the
QstartXML
software.
Note:
QstartXML
can only be installed on a Microsoft Windows computer with a Windows 7 or
higher operating system.
Creating and Configuring the Monitor Location
To ensure the most accurate results for each monitor location, the user must activate the
ECHO
monitor
with the correct configuration information in order to satisfy the specific monitoring needs of the project
and to record the desired data. The configuration information includes the location description, device
assignment and parameters, log rates, and other items relevant to the site and project requirements.
The configuration information is stored in an Extended Markup Language (XML) in the user’s local
directory or network drive. Certain elements of the XML are saved to the monitor memory during monitor
activation.
This section includes instructions on performing the following activities required for monitor configuration:
•
Creating a monitor location in
QstartXML
•
Selecting and editing devices
Содержание ECHO 9000
Страница 13: ...Introduction and Overview 1 9 First Page of the ECHO IECEx Certificate of Conformity ...
Страница 16: ...1 12 ADS ECHO Manual Sample ECHO Declaration of Conformity Page 1 ...
Страница 17: ...Introduction and Overview 1 13 Sample ECHO Declaration of Conformity Page 2 ...
Страница 61: ...Hardware Installation 3 21 Manhole Depth and Physical Offset Measurements ...
