ADS ECHO 9000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 40 / 105

2-22 ADS ECHO Manual
Note:
For all future communications following the initial activation, change the Connect
designation to Wireless to perform remote communications if the ECHO has a public static or
private static SIM card installed.
Verifying Wireless Communication
It is recommended that wireless communication be verified before installation of the monitor.
1. Ensure an antenna is attached to the ECHO .
2. Hold the magnet on the Wake activation point for 25 to 30 seconds until the SENSE LED illumines
magenta. Hold the magnet in place for another 1 to 2 seconds once this light illumines, then quickly
remove the magnet. The
SENSE light will begin to rapidly flash a green light and the COMMS LED
will be a solid green until connected to the network. Once the green light is flashing, wireless
communications will be enabled.
3. Change the connection type to Wireless and verify the IP address is correct.
4. Verify the COMMS LED is a slow flashing green light.
5. Attempt communication with the monitor by clicking the Status button.
6. If the monitor status information is displayed, wireless communication has been verified.
Monitor Status
7. Close the print preview of the status screen and click on the Hangup button in the Functions section
on the QstartXML main screen.
Saving the Configuration and Creating New Default
Location
1. Save the configuration by clicking the Save button at the bottom of the QstartXML main screen.
2. Clicking on the Set as Default button will update the default new location parameters to match how
the ECHO was just configured. This will allow the user to create a configuration template for all
subsequent ECHO monitor location. Clicking New will then populate the configuration with the
template parameters.