ADPRO iFT, Руководство по установке оборудования

Страница: 73 / 80

ADPRO iFT Series Hardware Installation Manual
27817_08 73
7. Click System halt .
8. Click Yes to confirm. The system shuts down all processes and connections. This may take a minute.
9. Wait for all the LEDs on the front panel to go out.
10. Switch off the power using the on/off switch at the back of the device.
Note
You have 20 seconds to switch off the device. After 20 seconds the device restarts again
automatically.
11. Unplug the power cord, and open the cover. The DOM is located at the back of the front panel:
12. Unplug the SATA cable that connects the DOM to the motherboard.
13. Unplug the DOM’s power cable.
14. Insert the SATA-to-USB cable into the DOM, and plug the other end into your PC.
Note
If you are using a new, unused DOM, you must format it first. When you connect the DOM to
your PC, the system will display a message, asking to format the DOM: click
Yes or OK to
format the DOM.
15. On your PC, double-click the FastTrace2ImageFlash.exe file to start the ImageFlash tool. The following
screen appears:
16. Click Browse and browse to the folder where the iFT image file is located.
17. Select the image file and click Open .
18. In the Disk box, select the DOM.
19. Click Flash .
20. Wait for the tool to complete the flash process.
21. Unplug the SATA-to-USB cable from the DOM.