ADPRO
iFT Series Hardware Installation Manual
27817_08
23
Caution!
l
Before installing hard disks, stop the device. Switch it off and unplug the power cord.
l
Take all necessary precautions to prevent static discharges that may damage the device: use an
anti-static wristband, an anti-static mat…
l
The procedure below assumes that you are using a
new disk
, or, in case of a used disk, that you
will
format the used disk
and erase all recordings on it. If you want to install a used hard disk
while keeping the recordings on it, follow the instructions in the Tech Tip
Recovering Recordings
from Used HDDs
(29160).
To install a third and fourth hard disk in an iFT-E device, proceed as follows:
1.
Stop the device, switch off the power supply, and then remove the top cover: unscrew 2 screws at the front,
4 at the top, and 3 at the back.
2.
Fix disks 3 and 4 on the mounting bracket (#17011920) using 8 disk screws (#17434080).
Disk 3
Disk 3 and 4
3.
Before mounting the bracket with the disk in the XO device, arrange the required SATA power and data
cables so that you can access them when the bracket is in place.
4.
Mount the bracket using 3 self-tapping screws (#17362010): use 2 screws to fix the bracket to the rear of the
device, and use the third screw to fix the bracket to the L-shaped bracket of the already installed second
disk.
Содержание iFT
Страница 1: ...ADPRO iFT Series Hardware Installation Manual February 2019 Doc 27817_08 Firmware version XO 4 03 ...
Страница 2: ......
Страница 79: ......