ADPRO iFT, Руководство по установке оборудования

Страница: 14 / 80

iFT Series Hardware Installation Manual ADPRO
14 27817_08
Caution!
l
Before installing hard disks, stop the device. Switch it off and unplug the power cord.
l
Take all necessary precautions to prevent static discharges that may damage the device: use an
anti-static wristband, an anti-static mat…
l
The procedure below assumes that you are using a new disk , or, in case of a used disk, that you
will format the used disk and erase all recordings on it. If you want to install a used hard disk
while keeping the recordings on it, follow the instructions in the Tech Tip Recovering Recordings
from Used HDDs (29160).
To install the first hard disk, proceed as follows:
1. Stop the device, switch off the power supply, and then remove the top cover: unscrew 2 screws at the front,
4 at the top, and 3 at the back.
2. Fix the hard disk to the bottom of the casing.
Caution!
If you tilt the casing, rest it carefully on the sides, but not on the back. You may damage the
connectors if you do.
Depending on the available holes in the casing and the hard disk, the following options exist:
o
Casing with 6 screw holes in the bottom: use the first 4 holes, or the outer 4 holes with 4 disk screws
(#17434080):
o
Old casing with 4 screw holes in the bottom: use 4 or only 2 disk screws (#17434080):