ADEMCO VISTA-10ES, Инструкция по установке и настройке

Страница: 18 / 80

VISTA-10SE Installation and Setup Guide
2-10
If no touch tones are produced following access to the
security system from on-premises (this problem may
arise in rare cases), it may be necessary to reverse the
wires connected to terminals 3 and 4 on the Phone
module and the wires connected to terminals (17) and
(18) on the control. The wiring diagram that follows
shows the wiring connections that will provide proper
operation in most cases.
Connection to the incoming telco line via a RJ31X jack
and direct-connect cord, as shown in Figure 2-11, is
essential, even if the system is not connected to a
central station. The 4285 or 4286 will not function if
this is not done and an error signal (fast busy signal)
will occur when trying to access the system via the
phone.
The house phone lines (gray and brown wires) must be
wired to the phone module terminals; not to the control
terminals. Otherwise, an error (fast busy signal) will
occur when trying to access the system from an on-
premises phone.
18
ANSWERING
MACHINE
TERMINALS
ON CONTROL
TO EARTH GROUND
(COLD WATER PIPE, ETC.)
SPEAKER VOLUME
ADJUSTABLE ON
4286 ONLY
UNUSED
KEYED
HEADER
4285/4286
V IP MODULE
12
3
4
5
6
7
YELLOW: TO DATA OUT (term. 7)
NO CONNECTION
RED:
TO AUX (+) (term. 5)
BLACK: TO AUX. GROUND (–) (term.4)
GREEN:
TO DATA IN (term. 6)
CONNECTOR
WITH FLYING
LEADS
TO CONTROL
PANEL
TERMINALS
USED FOR
KEYPAD
CONNECTIONS
PREMISES
ANSWERING
MACHINE
AND PHONES
Handset
Incoming
Teleco Line
TIP RING
RJ31X
JACK
PLUG
DIRECT
CONNECT
CORD TIP
RING
GROUND
(TIP)
(RING)
GREEN (TIP)
RED (RING)
INCOMING TELCO LINE
NO
CONNECTION
GREY (R) BROWN (T)
4285/4286
TERMINAL ASSIGNMENTS
1 - TIP
2 - RING
PHONE INPUT
3 - TIP
4 - RING
PHONE OUTPUT
5 - NO CONNECTION
6 -
7 -
AUDIO OUT
4286 ONLY
}
}
}
{ {
IMPORTANT NOTE FOR
EXISTING INSTALLATIONS:
EXISTING WIRES
CONNECTED TO THE
"HANDSET" TERMINALS ON
CONTROL MUST BE MOVED
FROM THERE TO TERMINALS
3 AND 4 ON THE 4285.
17 19 20
CALLER ID
UNIT
*
*
*
NOTE: IF THE TELEPHONE HAS BUILT-IN CALLER ID,
THE CALLER ID FUNCTION MAY NOT WORK.
21
CA38A
IN
CANADA
vip_mod_conn-V0
Figure 2-11. 4285/4286 VIP Module Wiring Connections
Standard Phone Line Connections
Connect incoming phone line and handset wiring to the
main terminal block via an RJ31X jack (CA38A jack in
Canada) as follows and as shown in Figure 2-12:
Term. 17: Local Handset (TIP – Brown*)
Term. 18: Local Handset (RING – Gray*)
Term. 19: Incoming Phone Line (TIP – Green*)
Term. 20: Incoming Phone Line (RING – Red*).
* Colors of wires in Direct Connect Cord
The wiring connections shown in Figure 2-12
are not applicable if a 4285/4286 VIP Module
is used.
Refer to the
Installing a 4285 or 4286 VIP
Module paragraph earlier in this section for
proper wiring information.