2-10
Adaptec ATA RAID 1200A Installation and User’s Guide
4
If you are connecting four hard disk drives, connect the gray
connector of the ATA/100 cable to the slave drive and go to
Step 5
.
5
Connect the blue connector of the second ATA/100 cable to the
channel 2 connector on the controller card, just as you did in
Step 1
.
6
Connect the black connector of the ATA/100 cable to the
remaining master drive.
7
Connect the gray connector of the ATA/100 cable to the
remaining slave drive.
Note:
Use the ATA/100 cables supplied with your Adaptec
ATA RAID 1200A controller kit for optimum performance.
Figure 2-9 Connecting Four ATA Drives
Set Mainboard CMOS Setup
The Adaptec ATA RAID 1200A card is a PCI Plug and Play device.
Therefore, you should not have to make any changes to the system
CMOS. The system should automatically assign the Interrupt and
Port address. To set the Adaptec ATA RAID 1200A card to be the
bootable controller, confirm in the system CMOS that the drive
types for on-board IDE controller drives are set to Not Installed or
None
. Alternatively, you can use the Boot to SCSI option if this
setting is available.
ATA RAID 1200A IUG.book Page 10 Wednesday, November 13, 2002 2:22 PM
