10 NEUROPROBE
®
500 PRO USER MANUAL
COPYRIGHT © 2006 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
Controls and Functions
A.
POWER button. Press for power ON; press again for power OFF. The display initial default screen reads:
SELECT
MODALITY
/
PROGRAM
/
TREATMENT
OFF.
B.
SELECT
PARAMETERS button. Pressing this button enters the SET mode, and displays the following
parameters: battery voltage, screen contrast, button speed A-B, button speed beat etc, button delay, audio, and
select laser type. Most stimulation parameters may be adjusted at any time during treatment.
C.
MODIFY
TIME/PARAMETER button. Use to increase/decrease the treatment time or to change parameters in
SET mode.
D.
LCD graphics screen for all functions and parameters. The graphics screen displays:
Modality selected
Program selected
Time remaining
Carrier Frequency
Bar graph for Vector and detection modes
Button speeds and delay
Vector selection
Output current
Display contrast
Sweep rate and modulation selection
E.
LEAD WIRE TESTER
connection and indicator LED. Plug the distal (patient end) of the lead wire into the test
connectors while observing polarity (red / black). Plug the device end of the lead wire into the receptacle
labeled LEAD WIRE TESTER. When the POWER is on, green LED will turn on if the lead wire passes the
test. LED will be red if the lead wires are faulty and need to be replaced.
F.
OUTPUT CHANNEL A in SENSORY, MOTOR, and NERVE BLOCK PADS programs.
G.
OUTPUT CHANNEL B in SENSORY, MOTOR, and NERVE BLOCK PADS programs.
H.
PATIENT
SAFETY switch. This is a remote duplicate of the START/STOP button. This is used by patients for
treatment interruption.
I.
PATIENT
GROUND
connection. Patient ground pads for use in conjunction with the Point Stimulation Probe.
H
A
B
C
D
E
F
G
I
K
L
M
N
O
P
Q
R
J
