77
10.10.3. Configuring speech dialler
The Speech Dialler function of the alarm panel describes the option of
sending a voice message to a (mobile) telephone in addition to the
digital transmission of a report to a command centre in the event of an
alarm.
The radio alarm panel has a built-in speech dialler. The radio alarm
panel can record five speech messages using its internal
microphone and replay them to a pre-programmed telephone
number to report an alarm. One message is called the “Home
message”, and is always played at the beginning of a report. You
should use this message to identify the radio alarm panel and it’s
location. The other four messages allow you record some indication
of the type of event causing an alarm, for example: “Fire” or
“Medical emergency”. The radio alarm panel plays these messages
after the home message.
The radio alarm panel can record up to 12 seconds of speech for the
Home message, and up to eight seconds of speech for each of the
alarm messages.
While programming the speech dialler you link each message with
the specific alarm type you wish to report. You then select a set of
destinations for each message, and each destination corresponds to
one of the telephone numbers you wish to call (see diagram below).
If a Social Emergency or Social Inactivity trigger starts a
speech call then the radio alarm panel also opens a speech path
the to the called number.
The person receiving the speech messages can control the link by
sending DTMF tones back to the radio alarm panel (usually by
pressing buttons on the telephone key pad).
Use the control buttons
to select
Speech Dialler
.
Confirm your
selection by pressing the control button
under the word
Select
. To
cancel input, press the control button
under the word
Back
.
If you confirm
Speech Dialler
with the
Select
button, you see the
following graphic display:
Use the control buttons
to select a
function
. For a list of functions
and their attributes, see the table below. Confirm your selection by
pressing the control button
under the word
Select
. To cancel
input, press the control button
under the word
Back
.
Function
Meaning
Call Mode
Setting for transmitting voice messages
Primary Telecoms
You must use this option to select which
route the radio alarm panel will pick first for
sending reports.
Messages
Recording of messages for voice messages
Phone Book
For entering phone numbers to which voice
messages are to be sent
Report Triggers
For linking the voice message to an event
Destinations
For linking the voice message to a phone
number
Call Acknowledge
Setting for confirming the voice message
To enable the Speech Dialler function, you have to set the function in
the Call Mode menu to
Enabled
.
