56
10.9.4. Answer on 1 ring
Use the control buttons
to select
Answer on 1 ring
.
Confirm your
selection by pressing the control button
under the word
Select
. To
cancel input, press the control button
under the word
Back
.
If you confirm
Answer on 1 ring
with the
Select
button, you see the
following graphic display:
Use the control buttons
to select when the panel accepts the
call. To select
Answer on 1 ring
, press the control button
under
the word
Select
.
To cancel input, press the control button
under
the word
Back.
If this function is enabled, the call to remote maintenance is in steps.
The software calls the station, waits for two rings and then hangs up.
This activates the panel to accept the call. If the next call arrives within
10 to 90 seconds, the panel accepts the call immediately. This skips the
Rings to Answer
function.
Note: When using "Answer on One Ring" set the number of rings in
"Rings to Answer" to a higher number than that used by the equipment
sharing the telephone line with the radio alarm panel. If you do not,
then the radio alarm panel will answer before the other equipment
.
10.9.5. Access mode
Use the control buttons
to select
Access Mode
.
Confirm your
selection by pressing the control button
under the word
Select
. To
cancel input, press the control button
under the word
Back
.
If you confirm
Access Mode
with the
Select
button, you see the following
graphic display:
Use the control buttons
to select an access mode function (see
Table 17) for remote maintenance by remote communication. To
select a number of rings, press the control button
under the word
Select
.
To cancel input, press the control button
under the word
Back.
