ABB ACL30, Руководство пользователя

Страница: 194 / 360

194 Parameters
02.15 EFB MAIN CW Internal Control Word of the drive received through
the embedded fieldbus interface.
Log. = Logical combination (i.e. Bit AND/OR Selection
parameter); Par. = Selection parameter. - / Pb
No. Bit/Name/Value/
Range Description Def/Type
FbEq
(16b/32b)
Bit Name Value Information Log. Par.
0 STOP* 1 Stop according to the Stop mode selected by
parameters
10.02 UP COMMAND or 10.03
DOWN COMMAND or according to the
requested stop mode (bits 2…6).
Note: Simultaneous stop and start commands
result in a stop command.
OR
10.02 ,
10.03
0 No action.
1 START 1 Start.
Note: Simultaneous stop and start commands
result in a stop command.
OR
10.02 ,
10.03
0 No action.
2 STPMODE
EM OFF* 1 Emergency OFF2 (bit 0 must be 1): Drive is
stopped by cutting off the motor power supply
(the inverter IGBTs are blocked). The motor
coasts to stop. The drive will restart only with
the next rising edge of the start signal when
the Run enable signal is on.
AND –
0 No action.
3 STPMODE
EM STOP* 1 Emergency stop OFF3 (bit 0 must be 1). Stop
within the time defined by
22.06 EM STOP
TIME.
AND –
0 No action.
4 STPMODE
OFF1* 1 Emergency stop OFF1 (bit 0 must be 1). Stop
along the currently active deceleration ramp.
AND 10.05
0 No action.
5 STPMODE
RAMP* 1 Stop along the currently active deceleration
ramp.
–
0 No action.
6 STPMODE
COAST* 1 Coast to stop.
–
0 No action.
7 RUN
ENABLE 1 Activate Run enable.
AND –
0 Activate Run disable.
8 RESET 0 -> 1 Fault reset if an active fault exists.
OR –
other No action.
(continued)
* If all stop mode bits 2…6 are 0, stop mode is ramp. Coast stop (bit 6) overrides the
emergency stop (bits 2/3/4). Emergency stop overrides the normal ramp stop (bit 5).