ABATEC WAVE.COM4, Инструкция по эксплуатации

Страница: 18 / 40

INSTRUCTION MANUAL
WE DO IT FIRST.
IMPORTANT!
If the control unit is used in the slave mode, the sauna
base unit has to be restarted (disconnect it from the
mains supply for a moment), so that the control unit can
be recognised. The recognition of the participants
occurs at the start-up of the sauna base unit.
Two colour control units with the same address should
not be connected at the same time.
The sauna and colour control unit are address-independent from each other. Therefore, the sauna
control unit can have the same address as the colour control unit.
3.11.0 VERSION DISPLAY
By pushing the , and buttons at the same time in the stand-by mode, the
software version number of the sauna control unit will be displayed for 3 seconds, i.e. “14”.
If you push the button within that period again, the software version number of the
control unit will be displayed with a “P” (like panel) in front of the number, in order to differentiate it
from the control unit (i.e. “P14”).
If you are using the control unit in the single/master mode (without base unit), only the control unit
version will be displayed. After the time has elapsed, the display returns to the stand-by mode.
4.0.0 IMPORTANT FACTS FOR INSTALLATION
ATTENTION!
This manual is supplied together with the installation
manual of the sauna cabin! Follow all instructions
concerning the cabin construction.
ATTENTION!
The electrical connections of the control unit must be
exclusively carried out by licensed specialists in
accordance with the provisions of the local power
supply companies. Use original parts only.
ATTENTION!
You should use a sauna heater that conforms to the
following standards: EN60335-1 and EN60335-2-53.
ATTENTION!
Please note that the EN60335-2-53 standard, table 101,
provides for a maximum heater output depending on
room size.
page 16 of 32