ABATEC WAVE.COM4, Инструкция по эксплуатации

Страница: 9 / 40

INSTRUCTION MANUAL
WE DO IT FIRST.
2.5.0 SETTING OF THE ELECTRONIC SANDGLASS
By using the button, go to time interval (electronic sandglass) and select the
desired temperature by using the button. After the time has expired, you will be able to hear
an acoustic signal. This signal can also be turned off (refer to 2.9.5).
2.6.0 DIMMING OF THE INTERIOR LIGHTING
By using the button, go to brightness and select the desired brightness by
using the button. After a short push of the button, the interior lighting will be turned off
and by using the button, the light will be fully turned on.
If you push the button longer you can change the brightness slowly and the light will be dimmed.
2.7.0 SETTING OF THE DESIRED HUMIDITY VALUE
(OPTIONAL WITH HUMIDITY MODULE)
By using the button, go to current and desired humidity and change the
desired humidity by using the button. After ca. 3 sec. without pushing any button, the control
unit changes automatically to the display of the current humidity.
Areas:
Depending on temperature. With 70 °C, a max. of 70 % rel. humidity can be selected and with
lower temperatures, a higher humidity can be selected. The max. value is reached at 41 °C with
99 % rel. humidity.
The sum of temperature in °C and humidity value in % shall not exceed the value of 140.
NOTE:
Area changes after a corrective value has been
selected. After starting the heater, it heats up until
the desired humidity and the desired temperature
has been reached. The water steamer has to be
furnished with a safety switch when a water
shortage is present.
page 7 of 32