ABATEC WAVE.COM4, Инструкция по эксплуатации

Страница: 17 / 40

INSTRUCTION MANUAL
WE DO IT FIRST.
3.8.0 USE OF SEVERAL COLOUR CONTROL UNITS
In order to use several sauna control units at the same time, each has to have its own address (0-
3). The control units ex factory have the address 0. To change the address, you have to do the
following:
Disconnect the 6-pole bus/supply cable from the control unit. Press the buttons at the same
time.
Reconnect cable during you press the buttons.
The display starts blinking and the address, which was set for that particular control unit, appears.
Change the address with the or button. Finally you have to confirm the new settings
with and jump to the “programming of the master/slave colour control unit” (refer to
3.9.0).
3.9.0 PROGRAMMING OF THE MASTER/SLAVE COLOUR CONTROL UNIT
Here you can change the settings and enter if the control unit is used in the
- slave mode:
Selection “SLA”, standard setting, with sauna base unit as master. For the activation of the
colour relay module, this mode is to use.
Or use the
- single/master mode:
Selection “SIN”, without sauna base unit.
Setting only for colour LED activation without sauna function (refer to instruction manual
colour LED module).
Change the selection by using the button or the button.
Confirm your settings by using the button and jump to the programming of the
“LED/REL menu” (refer to 3.10.0)
3.10.0 PROGRAMMING OF THE LED/REL MENU
Here you can set if the menu has to be adjusted to the activation of the colour relay module or the
colour LED module.
Difference: The relay module has 8 adjustable colours, the LED module has 7. The setting is only
efficient with the colour control unit with address 0.
The selection can be changed by using or . Confirm settings by pressing .
page 15 of 32