ABATEC WAVE.COM4, Инструкция по эксплуатации

Страница: 8 / 40

INSTRUCTION MANUAL
WE DO IT FIRST.
2.2.0 STARTING
The control unit must be connected to the power supply.
The left symbol lights up. If the time symbol also lights up, the automatic starting (for
programming refer to 2.9.1) is activated and the control unit turns on after the time has elapsed.
If you push the (OK) button, the control unit will be turned on and the interior light lights up.
Afterwards you have to select the operating mode (refer to 2.3.0).
2.3.0 SELECTION OF THE OPERATING MODE
After turning on (refer to 2.2.0) select the mode with the buttons “Feu” = Humidity mode
“Fin” = Finnish (dry) mode or “Aus” = turn off and confirm with the (OK) button.
The display changes automatically to temperature and starts heating with the last settings
entered.
2.4.0 SETTING OF THE DESIRED TEMPERATURE
By using the button, go to current and desired temperature and select with
the buttons the desired temperature. After ca. 3 sec. without pushing any button, the control
unit changes automatically to the display of the current temperature.
Areas: In Finnish mode < 110 °C and in humidity mode < 7 0 °C.
NOTE:
Area changes if a correction value for the
temperature will be entered (refer to 2.9.3). After
starting the sauna heater, the sauna heats up until
the desired temperature has been reached.
Ventilator: If and directly after are pressed, a connected ventilator will be activated.
To deactivate the ventilator, press and directly after .
page 6 of 32