ABATEC WAVE.COM4, Инструкция по эксплуатации

Страница: 19 / 40

INSTRUCTION MANUAL
WE DO IT FIRST.
The control unit must be connected in strict compliance with these instructions! Only use the
supplied original cables and original parts! We refuse to accept any responsibility for damage or
consequential damage caused by any parts supplied by other manufacturers or parts that have
been incorrectly connected.
Check all cables for damage. Even cables with minor damage (e.g. squashing, etc.) are
dangerous! Have such cables exchanged by service personnel immediately! We refuse to accept
any responsibility for damage or consequential damage caused by any damaged parts.
ATTENTION!
The control unit is ready for normal operation only after
all electrical and mechanical installation work (lighting,
etc.) has been completed!
5.0.0 COMPONENT INSTALLATION
ATTENTION!
Install the components only with a screwdriver and not
with a portable electric drill!
5.1.0 INSTALLATION OF THE POWER UNIT
The power unit will be preferable installed on the sauna cabin roof,
where all cables come together. Open the housing. The cover is
easily removable. The housing contains holes in the corners to
screw it tightly to the wall. The electrical connection must be
completed in accordance with the relevant standards. The
connection diagram is shown in section 6.
5.2.0 INSTALLATION OF THE SENSOR LINES
NOTE:
The sensor must be installed with the utmost precision, as
this is of decisive importance for the sauna climate.
The sensor lines should not be installed together with power
cables and should not be led through common holes, as this may
cause electronic malfunctions!
The sensor lines are not temperature-resistant. Therefore, they
must be installed outside the cabin or in the cabin wall!
page 17 of 32
fig. 5
fig. 4