ABATEC WAVE.COM4, Инструкция по эксплуатации

Страница: 10 / 40

INSTRUCTION MANUAL
WE DO IT FIRST.
2.8.0 SWITCH-OFF
In normal mode, the control unit changes to the operating mode (refer to 2.3.0) if you push the
button once. Now you can select “AUS” by using the button and press the button
to confirm. The control unit turns off.
If the humidity mode gets turned off, the control unit changes to the after-drying
programme. On the display appears “dry”. After the programme finished (normally 2 x 15 min),
the system will automatically be turned off.
Lighting and heater are afterwards turned off and the far left symbol lights up. We
recommend to fully switch-off by using the mains switch.
2.9.0 PROGRAMMING
2.9.1 AUTOMATIC STARTING
The mains switch has to be turned on and the control unit has to be in stand-by mode. Only the far
left symbol lights up. If you press both and buttons at the same time (3 sec.), you
can
programme the automatic starting. With the button, you can set the desired time between 1h
and 24h or you can turn it off. With the button you can select the desired mode
(similar to 2.3.0) and confirm with the button. (If the symbols and light up). The
automatic starting is activated. The digital display shows the hours remaining before switch-on
(countdown). The hour display only changes after every full hour. If outage occurs or when turning
on the control unit, the automatic starting will be deactivated.
2.9.2 AUTOMATIC SWITCH-OFF
The mains switch must be switched-on. In the stand-by mode, only the left symbol lights up.
If you push the and buttons at the same time (3 sec.), the automatic switch-off is
programmable. With the you can set the desired time between 1h and 12h, confirm it
with the button.
page 8 of 32