26
1. Make the first cut approximately 6
inches (15 cm) from the tree trunk. Cut
upward, from the underside of the
limb. Use the top of the guide bar to
make this cut. Cut a third of the way
through the diameter of the limb.
2. Make the second cut 2 - 4 inches (5 -
10 cm) farther out on the limb. Cut
downward, from the top of the limb.
Use the bottom of the guide bar to
make this cut. Cut completely through
the limb.
3. Make the third cut as close to the
tree trunk as possible. Cut upward,
from the underside of the limb stub.
Use the top of the guide bar to make
this cut. Cut a third of the way through
the diameter of the limb.
4. Make the fourth cut directly above
the third cut. Cut downward, from the
top of the limb stub. Use the bottom of
the guide bar to make this cut. Cut
completely through the limb stub to
meet the third cut. This will remove
the limb stub.
n
POLE HEDGE TRIMMER
Holding The Unit
1. Place the holding belt as shown in
the image and click onto the product
using the ring.
2. Always grip the unit firmly with both
hands when the unit is running.
Turning The Head Up And Down
Press the up/down rotary button (1) to
adjust the trimmer head angle. See as
below. Adjust the attachment angle to
fit the growth of the plant.
Adjusting The Pole Extension
1. Loosen the locking knob for length
adjustment completely and slide the
inner pole to the desired length.
2. To help maintain proper balance,
only extend the pole to the minimum
length required to reach the hedge
being cut. Hold the unit by the pole,
at the center of balance.
3. Screw the locking knob to lock the
inner pole in place firmly.
