20
CAUTION:
Only use
sawchain oil specfically recommended
for chainsaws that perform over a wide
range of temperatures with no diluting
required in the chain oil tank.
WARNING:
Do not use oils
with impurities as this could damage
the oil pump of the product.
WARNING:
Do not use motor
oil or any other petroleum-based oil. Do
not use dirty, used or contaminated oil.
Damage may occur to the guide bar or
saw chain. Dispose of old oil according
to local regulations.
n
POLE HEDGE TRIMMER
1. Remove the hex screw 1 and hex nut
with the hex wrench.
ATTENTION
! Place the
removed hex nut and screw well. Do
not miss them.
2. Lightly loosen other 4pcs hex screws
around the hex screw 1. It’s not
necessary to remove them.
3. Loosen the lock knob and pull out the
inner pole, then tighten the lock knob.
4. Put it into the opening powerhead
until the hole in the pole matches the
hole of the hex screw 1.
5. Insert the hex screw 1 and nut, then
tighten them and other 4pcs hex
screws.
6. Place guard as shown this Figure,
Insert the 4pcs screws and tighten
THE SHOULDER STRAP
1. Use your thumb or fingers to
squeeze the safety lock piece, put the
hook to the hanging part of the tool.
2. Move slide buckle to adjust the
length of the shoulder strap. Adjust
the length of the shoulder strap to
obtain a comfortable working position.
A few practices swings without
starting motor should be made to
determine correct balance.
3.
Put the shoulder strap over your
right shoulder. Carry the tool engine at
the right side of your body.
4. If the shoulder strap is too close to
your body, you can loose the hex screw
with hex wrench, then push the lock
ring further. When the distance is fit