6/1531-ANF 901 14 Uen F1 2013-11-29
43
M
OUNTING
& I
NSTALLATION
Temperature precautions
Pay some attention to the outside temperature influence on the Outdoor
housing built-in base station (see specification table above). An addi-
tional warming-up (for example, self limiting warming tape or mat) can
be needed in extreme low temperature areas. Opposite, a white or
silvery paint on the outside of the Outdoor housing reflects much of the
hot sunlight, if this housing is used in countries with high outside temper-
atures. Mount the housing under a sun protecting roof or on the shady
side of a building to prevent the built-in base station from overheating.
5.11.3 Mounting
of
the Outdoor housing
5.11.3.1
Mounting to a wall
The Outdoor housing can be easily mounted to a wall using standard
screws and plugs (not supplied, to be locally sourced). An installation
instruction is delivered with the box
It is recommended to place matching washers for 6 mm (1/4") screws
between the screw heads and the mounting flanges. For rough walls use
longer screws and insert appropriate distance sleeves between the
flanges and the wall to avoid damage of the Outdoor housing.
Weight
53 kg (base station not included)
Material
Enclosure and door:
fiberglass-reinforced unsaturated polyester
Rear mounting plate 2.0 or 3.0 mm sheet steel, zinc-plated.
Cable glands
1 x cable gland M 20x1.5, polyamide, RAL 7035 for local
power cable
1 x cable gland M 25x1.5, polyamide, RAL 7035 for data cable
Signal lamp holder
P9MLVD with green lens P9PDNVO and light bulb 24 Volt/2
Watt
Not included
function:
No cooling or warming up of the installed base station (Base
station operating temperature range: -10°C to +55°C)
No lightning protection
Compliance to:
Regulations and standards
Electrical safety
IP66
Approvals
UL, CSA and Australian
Pole mounting set:
NTM 501 04 (optional)
Set materials
2 mounting angles, 600 mm long
4 x clamping sections
2 x clamping straps
4 x clamping brackets
4 x screws and nuts (M8) for mounting the set to the outdoor
housing
1 x installation instruction
