Installation
138
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
4. 7. 5
Equipment on the ODAB options card
The ODAB options card contains the following equipment:
• 1 analogue terminal interface for connecting a door intercom
• Control outputs and control inputs for connecting a door intercom and/or other
purposes.
With the aid of jumpers the options card is configured for connecting a door inter-
com or provides control inputs and control outputs:
• In the configuration as a door intercom the option card must be fitted to slot IC2
(Aastra 415) or IC4 (Aastra 430). The interfaces are then available at RJ45 sockets
2.1...2.3 (Aastra 415) and 4.1...4.3 (Aastra 430).
• If the option card is used for other purposes, it must be fitted to slot IC1 (Aastra
415) and IC1...3 (Aastra 430). The RJ45 socket x.1 then provides two control out-
puts and the RJ45 socket x.2 two control inputs.
• The possible RJ45 sockets are highlighted in colour in the figure below.
Fig. 62
Interfaces of the ODAB options card
4. 7. 5. 1
Connection of a door intercom (TFE)
If the options card is fitted to slot IC2 (Aastra 415) or slot IC4 (Aastra 430), an ana-
logue terminal interface is available for connecting a door intercom.
Note:
This analogue terminal interface cannot be used for other purposes as
the software does not support it.
Jumper Configuration
The jumper configuration is shown in the following diagram. Three of the four IO
ports are used for connecting the door intercom. A control input or a control out-
put is available for other purposes.
