Operation and Maintenance
195
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
6. 3. 3. 3
New card with more ports
A card is replaced by a similar card with more ports.
Procedure:
1. Change the card and put the system into operation again. Similar procedure as
described in
"Replacing a defective interface card", page 193
.
2. In the WebAdmin view
Cards and modules
(
=4g
)
Confirm
the new cards.
3. Configure new ports.
The system configuration data (User No., User configuration, etc.) of the terminals
on the new ports is created as new data (default values).
Tab. 83
Example: Expanding the number of terminal or network interfaces
6. 3. 3. 4
Change slot
Interface cards can be moved to a different slot. The terminal configuration data of
the system phones can be transferred.
Procedure:
1. Change the slot and put the system into operation again. Similar procedure as
described in
"Replacing a defective interface card", page 193
.
Note:
The wiring adapter must also be changed to the corresponding slot.
Any incorrectly fitted or missing wiring adapters are signalled by a red
flashing LED on the display after start-up (see
"Wiring Adapter Mal-
function Mode", page 209
).
2. Connect the system terminals to the ports of the new slot.
3. Reconfigure the port assignment.
4. In the WebAdmin view
Cards and modules
(
=4g
)
Confirm
card in the new slot
and
Delete
it from the old slot. The configuration data at the old slot location is
now deleted.
Note:
Not all cards can be equipped on all slots (see
"Component mounting
rules", page 100
).
TIC-2TS
TIC-4TS
The configuration data of terminal interfaces 3 and 4 are created as new.
TIC-2AB
TIC-4AB
The configuration data of network interfaces 3 and 4 are created as new.
