Chapter 32 Link Layer Discovery Protocol (LLDP)
XGS1930 Series User’s Guide
262
32.7 LLDP-MED Configuration
Click
Advanced Application
>
LLDP
>
LLDP-MED Configuration
to display the screen as shown next.
Figure 187
Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
32.8 LLDP-MED Network Policy
Click
Advanced Application
>
LLDP
>
LLDP-MED Network Policy (Click Here)
to display the screen as
shown next.
Table 130 Advanced Application > LLDP > LLDP-MED Configuration
LABEL
DESCRIPTION
Port
This displays the Switch’s port number. Select * to configure all ports simultaneously.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location
Select to enable transmitting LLDP-MED location TLV.
Network Policy
Select to enable transmitting LLDP-MED Network Policy TLV.
Apply
Click
Apply
to save the changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Summary of Contents for XGS1930-28HP
Page 19: ...19 PART I User s Guide...
Page 39: ...39 PART II Technical Reference...
