Chapter 13 Spanning Tree Protocol
XGS1930 Series User’s Guide
140
Configuration
to activate one of the STP standards on the Switch.
13.3 Spanning Tree Configuration
Use the
Spanning Tree Configuration
screen to activate one of the STP modes on the Switch. Click
Configuration
in the
Advanced Application
>
Spanning Tree Protocol
.
Figure 106
Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
13.4 Rapid Spanning Tree Protocol Status
Figure 107
Advanced Application > Spanning Tree Protocol
Table 61 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select
Rapid Spanning Tree
or
Multiple Spanning Tree
.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Summary of Contents for XGS1930-28HP
Page 19: ...19 PART I User s Guide...
Page 39: ...39 PART II Technical Reference...
