ZyXEL Communications Prestige 650ME, User Manual, Page: 69 / 199

Prestige 650ME ADSL Bridge
Remote Node Configuration 4-5
Table 4-1 Remote Node Profile Menu Fields
FIELD DESCRIPTION EXAMPLE
Period (hr) This field is the time period that the budget should be reset.
For example, if we are allowed to call this remote node for a
maximum of 10 minutes every hour, then the
Allocated
Budget is (10 minutes) and the Period (hr) is 1 (hour).
0
Schedule Sets This field is only applicable for PPPoE encapsulation. You
can apply up to four schedule sets here. For more details
please refer to the
Call Schedule Setup chapter.
Nailed up Connection This field is only applicable for
PPPoE encapsulation. This
field specifies if you want to make the connection to this
remote node a nailed-up connection. More details are given
earlier in this section.
No
Session Options
Edit Filter Sets
Use [SPACE BAR] to choose Yes and press [ENTER] to
open menu 11.5 to edit the filter sets. See the Remote Node
Filter section for more details.
No
Idle Timeout (sec) Type the number of seconds (0-9999) that can elapse when
the Prestige is idle (there is no traffic going to the remote
node), before the Prestige automatically disconnects the
remote node. 0 means that the session will not timeout. 0
Edit Traffic Redirect
Press [SPACE BAR] to select Yes and press [ENTER] to go
to Menu 11.7 – Traffic Redirect Setup . See section 4.4 .
No
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors’ implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.