ZyXEL Communications Prestige 650ME, User Manual, Page: 171 / 199

Prestige 650ME ADSL Bridge
Remote Management 15-3
Table 15-1 Menu 24.11 – Remote Management Control
FIELD DESCRIPTION EXAMPLE
Secured Client IP The default 0.0.0.0 allows any client to use this service to remotely
manage the Prestige. Enter an IP address to restrict access to a client
with a matching IP address. 0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
15.4.2 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1. A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
2. You have disabled that service in menu 24.11.
3. The IP address in the Secured Client IP field (menu 24.11) does not match the client IP address.
If it does not match, the Prestige will disconnect the session immediately.
4. There is an SMT console session running.
5. There is already another remote management session of the same type (Telnet, FTP or Web)
running. You may only have one remote management session of the same type running at one
time.
6. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.
15.5 Remote Management and NAT
When NAT is enabled:
Use the Prestige’s WAN IP address when configuring from the WAN.
Use the Prestige’s LAN IP address when configuring from the LAN.
15.6 System Timeout
There is a system timeout of five minutes (300 seconds) for either the console port or Telnet/web/FTP
connections. Your Prestige will automatically log you out if you do nothing in this timeout period, except
when it is continuously updating the status in menu 24.1
or when
sys stdio
has been changed on the
command line.