ZyXEL Communications Prestige 650ME, User Manual, Page: 36 / 199

Prestige 650ME ADSL Bridge
2-8 Hardware Installation and Initial Setup
2.7.1 Initial Screen
When you turn on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige asks you to press
[ENTER] to continue.
Figure 2-6 Power-On Display
2.7.2 Entering Password
The login screen appears after you press [ENTER] , prompting you to enter the password, as shown next.
For your first login, enter the default password “1234”. As you type the password, the screen displays an
“X” for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your Prestige will
automatically log you out and will display a blank screen. If you see a blank screen, press
[ENTER] to
display the login screen again.
Figure 2-7 Login Screen
2.8 Resetting the Prestige
If you forget your password or cannot access the Prestige, you will need to reload the factory-default
configuration file. Uploading the configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had previously and the
speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and
flow control set to none. The password will be reset to “1234” and the LAN IP address to 192.168.1.1 also.
Refer to the chapter on Firmware Maintenance for detailed, step-by-step instructions.
Enter Password : XXXX
Copyright (c) 1994 - 2002 ZyXEL Communications Corp.
initialize ch = 0, ethernet address: 00:a0:c5:01:23:45
Wan Channel init ........ done
Loading ADSL modem F/W
................................................................. done
Press ENTER to continue...