ZyXEL Communications Prestige 650ME, User Manual, Page: 79 / 199

Prestige 650ME ADSL Bridge
Remote Node TCP/IP Configuration 5-3
Table 5-2 TCP/IP Remote Node Configuration
FIELD DESCRIPTION EXAMPLE
My WAN Addr Some implementations, especially UNIX derivatives, require separate
IP network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the
IP address assigned to the WAN port of your Prestige.
NOTE: This field refers to local Prestige address, not the remote router
address.
NAT Select SUA Only if you have just one public WAN IP address for your
Prestige. See section on NAT for more information.
Select None to disable NAT.
SUA Only
Metric The metric represents the “cost” of transmission for routing purposes.
IP routing uses hop count as the cost measurement, with a minimum of
1 for directly connected networks. Type a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number. 2
Private This determines if the Prestige will include the route to this remote node
in its RIP broadcasts. If set to
Yes , this route is kept private and not
included in RIP broadcast. If No , the route to this remote node will be
propagated to other hosts through RIP broadcasts.
Yes
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are
Both , In Only , Out Only or None .
Both
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are RIP-1 , RIP-2B or RIP-2M .
RIP-2B
Multicast IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
None disables IGMP.
IGMP-v2
IP Policies You can apply up to four IP Policy sets (from 12) by typing in their
numbers separated by commas. 3, 4, 5, 6
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
5.1.1 IP Static Route Setup
Static routes tell the Prestige routing information that it cannot learn automatically through other means.
This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is
directly connected to a remote node.