ZyXEL Communications Prestige 650ME, User Manual, Page: 70 / 199

Prestige 650ME ADSL Bridge
4-6 Remote Node Configuration
4.2 Remote Node Setup
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [ SPACE BAR ] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Figure 4-3 Remote Node Network Layer Options
The next table explains fields in Menu 11.3
–
Remote Node Network Layer Options .
Table 4-2 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment Press [SPACE BAR] and then [ENTER] to select Dynamic if the
remote node is using a dynamically assigned IP address or Static if it
is using a static (fixed) IP address. You will only be able to configure
this in the ISP node (also the one you configure in menu 4), all other
nodes are set to
Static .
Static
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet Mask Type the subnet mask assigned to the remote node.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Static Ethernet Addr Timeout(min)= 0
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies= 3,4,5,6
Press ENTER to Confirm or ESC to Cancel: